Hello all,
I am new to these boards - I did have a search but didn't find anything specific for the issue I am seeing so apologies for the new thread.
I am coming across an issue with a server I have when I configure the onboard Intel RMM4.
I configure the RMM as dedicated (rather than a shared interface) with the correct IP address etc. Once configured, I can ping RMM fine. Logging into IE and connecting to the RMM, then navigating a few pages within the RMM the page becomes unresponsive and the ping is unreachable.
I have had this with two separate servers now.
The RMM4 can ping then I login to the RMM GUI and after a short while the ping becomes unreachable. (Have been running a ping -t in the background - ping is working fine, then all of a sudden it drops.)
I have confirmed network is not an issue, or config of IP addresses etc. Have attempted connecting laptop direct to management port / RMM4 interface and still unable to ping.
Does anyone have any ideas in this matter?
Thanks in advance
Richard
I have provided a more detailed set of steps carried out on the new server below:
Installed new server
Configured RMM
ipmitool lan set 3 ipaddr 10.2.211.131
ipmitool lan set 3 netmask 255.255.255.0
ipmitool lan set 3 defgw ipaddr 10.2.211.1
(note customer network interface is configured as 10.2.211.130)
ping 10.2.211.131 success
Load IE and connect to RMM GUI, logged in
After a short while session becomes unresponsive.
ping unreachable
reboot - still can’t ping RMM
Hard power off server by pulling power cables, wait for server to come up - can ping RMM.
Run RMM GUI, with -t ping in background, after navigating a few screens ping becomes unreachable.
Check BIOS and RMM config (will try and attached photo). Correct configuration.
ipmtool lan print 3 shows correct config