Re: Modular server array rebuild taking more than a week
Thanks, Dan. The five drives are a mix of Seagate ST9146802SS and ST9146803SS. The estimated completion time is now estimated at 2,225 hours. The Front I/O Fan part number is D70745-403. Are you...
View ArticleS1200BTS does not complete POST
Hi,I've been running my S1200BTS with a Xeon E3-1230 and 2 KVR1066D3E7S/4G (total 8G) with AHCI set now for 22 months without a problem. 1 month ago I reconfigured storage to use Intel Rapid Storage...
View ArticleRe: S1200BTS does not complete POST
When you say "BIOS Boot fails", do you get anything on the screen? Any error messages? Do you mean you can still go to BIOS and change settings like boot order? And when you say "Server restarted but...
View ArticleRe: S1200BTS does not complete POST
Hi Edwardzh, "BIOS Boot fails" - power applied to board, front panel switch used to initiate BIOS bootup but Intel splashscreen not shown and Intel Diagnostic Lights at rear of server board display...
View ArticleRe: S1200BTS does not complete POST
Reseat processor. Test the CPU on another system if possible. If the CPU works, then most likely the board has failed.
View ArticleRe: S1200BTS does not complete POST
Hi Edward, I have tried reseating the processor with the same result - ie. Intel Diagnistics Light 0x15. I won't have another board to try until tomorrow but your advice seems to back my deduction of...
View ArticleRe: Intel S1200BTL bios downgrade
Yes we tried. Thank you for answer Dan_O, we have alredy fix this isssue by replacing raid controller from adaptec to areca.
View ArticleTPM Measurement
For TPM enabled Intel Server Boards is there any document that describes what is being measured and stored in PCRs? I have looked at the Technical Product Specifications for a number of boards found...
View ArticleRe: S1200BTS does not complete POST
UPDATE:A new S1200BTLR board was tried with:CPU: the Xeon E3-1230 that was removed from the suspect S1200BTS boardMemory: single Kingston KVR13E9/8IThe S1200BTLR POSTed successfully...
View ArticleRe: Setting up Raid5 on S2600cp4
Here is the hardware Intel S2600CP4 system board Intel P4000 chassis Intel Xeon E5-2620 CPU (dual) Intel Raid c600 rksata8r5 64gb Kingston DDR3 ECC 1600 memory 3 X 2tb Western digital enterprise (RAID...
View ArticleClik here to view.
Re: Setting up Raid5 on S2600cp4
Unfortunately ESRT2 doesn't support UEFI boot. You'll need to create a VD less than 2TB for OS installation, and you can create a second VD using the remaining capacity for data storage.
View ArticleClik here to view.
SS4000-E 100% Full Can't access data, enable FTP, or SSH
I've been using this Grrrrreat NAS Array and had been working for YEARS. Just last week it is now 100% Full and my share is gone. It has FW fs-bc 1.3-b524, 4 x 500GB HD's and a 1.3TB shares (but i...
View ArticleClik here to view.
Re: MFSYS25 Switch module problem
Hello, We have the same problem, it started with once a month and now somtime once an hour. Cleaning the module and the contacs did not give a solution. No useable mentions in the log-file. Soft reset...
View ArticleClik here to view.
Re: P4308RPLSHDR mounting RAID cache battery
VELCRO to the chassis floor is the ONLY answer.
View ArticleRe: Modular server array rebuild taking more than a week
If the 10K.2 drives and the 10K.3 drives are in the same storage pool, that could also be contributing. The stale drive can be ejected. The RAID should be rebuilding from everything except that drive,...
View ArticleRe: MFSYS25 Switch module problem
Jean Paul - If the switch is dropping every hour, it may need to be replaced.
View ArticleRe: P4308RPLSHDR mounting RAID cache battery
do you think the heat inside the chassis will affect the adhesive that holds the velcro to the metal?
View ArticleRe: P4308RPLSHDR mounting RAID cache battery
It's Ireland we don't do heat... Velcro'ed to floor of server so nowhere to fall...we don't do earthquakes either over here A design omission on Intel's behalf. The P4308 chassis have nowhere...
View ArticleRe: SS4000-E 100% Full Can't access data, enable FTP, or SSH
Marcop300, I don't know if this will help and it's been a long time since I worked with the Intel® Entry Storage System SS4000-Es. I went through some old archives I had and put this together....
View ArticleRe: TPM Measurement
I don't see any level of detail like that, in any of the public documentation. Are you looking for a board that specifically changes the value of PCR1 when something like the BIOS boot order changes?
View Article