Re: Intel S2600GZ Server SSD Issue
Thank you David. This is what I was telling to my Boss, Now I got prove & need connector or converter for power.
View ArticleClik here to view.
Re: RMS25CB080 performance
Hi ! The tests posted above (in the first post) were made directly on host running Windows 2012 R2 Standard (Hyper-V root partition). The performance diference inside VM (Hyper-V child partition) is...
View ArticlePCI\VEN_8086&dev1503 Windows Server 2012 r2 Ethernet Driver
good day. Is there any drivers for this device on Win Server 2012 r2 ?
View ArticleRe: CentOS 6.6 Intel SRCSAS18E
We have done validation to Red Hat Operating System up to 5.0 Update 3. My concern is that if the RAID controller is not initializing properly you might not be able to access the volume. I would...
View ArticleRe: PCI\VEN_8086&dev1503 Windows Server 2012 r2 Ethernet Driver
You will get a better response in the Servers forum.I have moved your post there. Doc
View ArticleRe: CentOS 6.6 Intel SRCSAS18E
I will try unplugging the drive connections and see if I can get into <ctrl+g> / RAID BIOS. I did also note your comment about "Tested to CentOS 5.3" but the website does not RHEL (CENTOS) 6...
View ArticleRe: PCI\VEN_8086&dev1503 Windows Server 2012 r2 Ethernet Driver
Based on the information provided, it seems that you are using an Intel® 82579V Gigabit Ethernet controller. I can always confirm this information with the model of your system board. You can locate...
View ArticleRe: S1200BTLRM: Status LED blinking amber
I found out that the BMC was monitoring all fan headers and it was missing one. After I installed one fan more, there was no blinking amber, just solid green status. :-)
View ArticleClik here to view.
S1200BTLRM: ipmitool unable to establish session
Hi, I have installed Ubuntu 14.04 and ipmitool. LAN1 is used as channel 1 and there is different IP address for OS than for BMC and default GW has been set also. Ipmitool is successful in executing...
View ArticleW2600CR Bios Issue (Fans runs @ Max)
We purchased 8 W2600CR servers around end of November 2014. We built and config'd 5 of them then updated bios to make fans runs quite all work well. Now over the last week we have completed the last...
View ArticleRe: S1200BTLRM: ipmitool unable to establish session
Just to be clear, is this only working locally but you are not getting any output when trying to remote access the unit? Would it be any firewall configuration that might be blocking the access to it?...
View ArticleClik here to view.
S2600CP P4308CMHEN Fan Noise
Halo to all, I have an Intel Server P4308CMHEN with the S2600CP.Board Information: Product Name : S2600CP | Serial Number: QSCP35000469 | Part/Model Number : E99552-510 | FRU File ID : FRU Ver 1.00 I...
View ArticleINTEL P4308RPLSHDR SERVER SYSTEM WITH RSBL080
I have 2 servers like this. Issue with both is that hotspares fail on patrol reads. I narrowed it down to the fact they go from power transition to unconfigured bad state when patrol read starts. I...
View ArticleRe: W2600CR Bios Issue (Fans runs @ Max)
What is the current state of the status LED of the board? Could you please confirm the model of the chassis is being used? Remember to properly close the side cover of your chassis as this might cause...
View ArticleRe: S2600CP P4308CMHEN Fan Noise
I checked the SEL log file you sent and I noticed that it is showing errors for the Chassis intrusion switch. This entry will make the fans to run at full speed. I would recommend making sure that the...
View ArticleRe: W2600CR Bios Issue (Fans runs @ Max)
Hi David, Thanks for your reply, We have a single green led once machine has booted to windows & using the P4000ip chassis bios was updated using the windows one boot flash util. Thing is when you...
View ArticleRe: W2600CR Bios Issue (Fans runs @ Max)
Were you able to check if the side cover is properly mounted? I would probably try the EFI update instead to see if it has the same effect. If the fans are able to run slow during the BMC update, it...
View ArticleRe: S2600CP P4308CMHEN Fan Noise
Hi David first of all thank you for the prompt reply. I removed and paced back again the cover as you suggested, but it didn't solved the problem. Actually I haven't opened the cover before or after...
View ArticleClik here to view.
S2600GZ RAID upgrade
We are using S2600GZ as our main server platform with its onboard Intel RST RAID and WD 10krpm SATA drives (RAID10). All servers are running Hyper-V role and Win/Linux virtual machines. I'm trying to...
View ArticleS1200BTL startup error
Hey,I have an old server with S1200BTL with E3-1220 and 2x2 GB ram.The server worked fine for a while, after that was discontinued. Now i'm trying to use it again, but it doesn't boot.It powers on...
View Article