Re: S2600GZ MB based system attempts to boot, fans attempt to power up and...
If there is any short in the power supply, would the fuse just short it self? I'd think the power supply is failing. Power supply does decline over time. I've had several PSs, which can still boot up...
View ArticleClik here to view.
Re: DirectPDMapping
Hi!After further investigating here, we confirm that While the DirectPdMapping command is not available in UEFI when using CmdTool2 (see the “UEFI Command Line” section on page 7 of the Command Line...
View ArticleRe: плата intel s3420gpc и hdd SATA 3Tb
I am glad the situation was resolved with a 2TB. hdd. Thank you for the feedback!
View ArticleClik here to view.
Re: R1304WT2GS raid drivers for Microsoft Server 2012 r2 standard, Intel...
Hi!Just to be in sync, the most current RAID drivers are found at the following URLs:ESRT2 RAID driver for Windows*RSTe RAID driver for Windows* Hence, if you selected ESRT2 as the onboard RAID...
View ArticleClik here to view.
Clik here to view.
Re: DirectPDMapping
Are there permissions that need to be set first on the RAID module to allow me to set this parameter? Scott
View ArticleRe: плата intel s3420gpc и hdd SATA 3Tb
Next time, post with English, so you can get more help.... Do not understand Russian....
View ArticleClik here to view.
RS3DC0080 combined with RES3TV360 on R2224WTTYS
I have the intel server system R2224WTTYS with RS3DC0080 Raid card and the RES3TV360 SAS expander. When everything is connected up I only see it linked to the expander on ports 0 - 3 rather than 0 - 7...
View Articles5000psl will not boot, status led solid green/amber
I just bought a used intel s5000psl from ebay, it was just the bare board with 2 xeon 5140 and 4gb of ram. Ive got a 680w atx power supply plugged upto the board, it didnt come with a case/rack so i...
View ArticleRe: s5000psl will not boot, status led solid green/amber
There are onboard LEDs and front panel LEDs. Some chassis even have back panel LEDs. You need to make it clear. Certain boards are stock boards, but certain boards are made slightly differently for the...
View ArticleClik here to view.
Re: s5000psl will not boot, status led solid green/amber
The board did not come with a chassis and i do not currently have it in one, the LED's i was talking about are the onboard system ID, and status LED's labeled in the picture below as A and B since...
View ArticleRe: s5000psl will not boot, status led solid green/amber
Ugh go figure , the 8pin cpu power cable had the 12v+ and ground flipped , i switched the pins and it booted right up , ill start a new thread if i need more help. thank you.
View ArticleClik here to view.
Re: s5000psl will not boot, status led solid green/amber
This is odd. You lucky the board was not fried. Good luck...
View ArticleRe: RS3DC0080 combined with RES3TV360 on R2224WTTYS
It seems that the controller is only seeing the drives connected in port 0-3. If it is not seeing the drives in 4-7, then it might be a problem with the cable or with the port on the backplane. I would...
View ArticleRe: RS3DC0080 combined with RES3TV360 on R2224WTTYS
Yes, switch the cable around at the RAID controller side. You may want to connect just one cable at a time, say, ports 4-7, to see what happens. Also, what does it say at BIOS level?
View ArticleClik here to view.
Can you use an DPS-830AB power supply in a 5300 BRP Case instead of the...
Can you use an DPS-830AB power supply in a 5300 BRP Case instead of the DPS-730AB? They look the same and the only difference I can find is one is 100 Watts bigger. Thanks
View ArticleRe: Can you use an DPS-830AB power supply in a 5300 BRP Case instead of the...
Sure, give it a try. Some of the servers come with 400 W PS...
View ArticleRe: RS3DC0080 combined with RES3TV360 on R2224WTTYS
The connection in the bios reflects the same thing 0-3 on the RES3TV360. I have two of these setups and they are acting identically. When I connect just 4-7 I see everything on 4-7. I have rotated...
View ArticleRe: RS3DC0080 combined with RES3TV360 on R2224WTTYS
If all cables (and ports) are good, both the main board and the RAID board work, then this points to the BIOS. I do not see how this can happen. Can you try to update the BIOS (or just reset BIOS to...
View Article