S5000PSL fan speed
Recently just got this server up and running and i bought 2 stock intel LGA 771 heat sinks w/fan for it and for some reason they always run at 100%, it literally sounds like im running a shop-vac in my...
View ArticleRe: S2600-CP2 vmware ESXi 5.5 hangs on ACPI initialization -- Boot loop
Thanks, your chat with Intel support had all the clues, but it took me 20+ tries to pick up the key points I ended up with this more elaborate script.Highlighted the key points. Issue: ESXi 5.5 upd 2...
View ArticleRe: S5000PSL fan speed
In this case, I would check the logs of the system to see what is being recorded that would trigger the fans to run at full speed. I would suggest running the latest firmware package (see update...
View ArticleClik here to view.
Re: DirectPDMapping
Hi!Thank you for the further details. If you tried with another Intel® Integrated RAID Module RMT3CB080 at no avail, please, know the situation will go under further investigation. Once we havefurther...
View Articleintel s5000vsa sata board raid configure support needed
i m planning to install two sata hard drives of 500gb each.i want to configure raid 0 on two hard drives.i want to install win7 64bit . kindly any one guide me to do the above task. i set SATA as...
View ArticleRe: Help w/Adjusting SDR Max Fan Speeds for P4000 S1200RPL V3
Since you are using an Intel board in an approved and tested Intel chassis, i would be very leery of trying to change the SDRs,However, i would recommend checking the system thermal readings and fan...
View ArticleInterpretation of POST LED displays missing in documentation.
After some initial hiccups, I was able to get the Intel motherboard to at least power up. Now it does not start the boot process. I tried to understand the LED displays which explain problems...
View ArticleClik here to view.
Re: Help w/Adjusting SDR Max Fan Speeds for P4000 S1200RPL V3
Thanks for the detailed response.You are dead on correct about everything. I eventually determined the CPU temp was the driver using some temp monitoring software. Under load it was getting up into...
View ArticleRe: intel s5000vsa sata board raid configure support needed
You connect the HDs, then set up the BIOS SATA to RAID. Power off, power on. Then you set up the RAID at BIOS level. After the RAID is enabled, at BIOS bootup, you'll see the prompt to press key stokes...
View ArticleRe: S5000PSL fan speed
Some setup is clearly off. Most of the Intel server boards have hardware control capability. All the fan speed and temp control is done by a chip, like BMC. At cold bootup, the fans will be running at...
View ArticleRe: Interpretation of POST LED displays missing in documentation.
What board?? Do not understand why you try to boot the board without any RAM. That would be certainly no boot and you won't get any meaningful diagnosis info....
View ArticleRe: Help w/Adjusting SDR Max Fan Speeds for P4000 S1200RPL V3
Sounds about right. Some day I will figure out why we only spec Tcase since we only report Tcore.Tcore runs ~10+\- degrees higher the Tcase so the system is responding correctly (if loudly) the the CPU...
View ArticleRe: intel s5000vsa sata board raid configure support needed
Thanks for the guide sir.i test & get back to u
View ArticleClik here to view.
Re: Interpretation of POST LED displays missing in documentation.
I tried to boot without RAM only to see if the POST LED reading I was doing was indeed right. The problem that I HAD is the there was no explanation to the POST LED error reading I was getting. I got...
View ArticleRe: Interpretation of POST LED displays missing in documentation.
Which Mainboard do you use?
View ArticleRe: Intel 82574L NIC drivers for Windows 2012 R2
Hi, I also asked another vendor for this issue in the past. They told me that there isn't any validated 2012R2 driver for this network card and I have to use the microsoft driver.
View ArticleS5000PAL Does not boot to Bios
Hi server guru's,I have a SR2500ALLX chassis with a S5000pal board that will not boot to bios.This is a retired server I was resurrecting for additional storage and running a virus solution.I had just...
View ArticleRe: Interpretation of POST LED displays missing in documentation.
I am using Intel S1200v3RPS motherboard. Sorry, should have mentioned that.
View ArticleRe: S5000PAL Does not boot to Bios
It appears that the issue could be related to the RAID controller and not the system BIOS. Are you able to enter the RAID BIOS when CTRL+G is prompted?You may want to remove the memory module and the...
View Article