Re: S5000PAL Does not boot to Bios
If the system worked before with other OSs, and you did not change hardware, then the system should be just fine. You did not say how you installed Win 7. Was a clean install? or upgrade? It appears...
View ArticleRe: Can you use an DPS-830AB power supply in a 5300 BRP Case instead of the...
Received the two DPS830 power supplies in today. I first just installing one in the server with a DPS-730 and the server did not really want to boot up. Pulled the 730 out and it booted up just fine...
View ArticleRe: S5000PAL Does not boot to Bios
Good point on the activation key and mem module. I will try that.I am unable to enter Raid config. Message may or may not state "entering raid console after post completes" (depending on how soon you...
View ArticleSR2625urlxr power supply fan always On
Is the power supply fan on SR2625urlxr always on even if the server is shutdown?
View ArticleClik here to view.
SR2625urlxr Embeded SROMBSASMP2 Raid Disappears
I noticed that my SROMBSASMP2 raid is not detected on SR2625urlxr (which was powered off for some time) andI can only get it back if I remove the cmos battery and put it back on . It uses firmware...
View Articleraid support for INTEL S5000VSA needed
sir1. i connected 500gb seagate sata hdd on sata0 port & 4tb seagate sata hdd on sata1 port on intel S5000VSA server board.2. Then i went to bios & enabled sata as RAID. then i saved the...
View ArticleRe: S5000PAL Does not boot to Bios
Update:removed the midplane memory module and activation key and successfully booted into Bios.cleaned and re-installed. same issue.Removed the 5 HDD's and was able to hit "C" and get into the raid...
View ArticleRe: raid support for INTEL S5000VSA needed
Make sure to update to the latest BIOS first. Test the RAID with two small sized drives, smaller than 2 TB. A lot of the boards have problems with drives larger than 2 TB...
View ArticleRe: intel s5000vsa sata board raid configure support needed
Please do not duplicate posts. This is answer at other thread...
View ArticleRe: S5000PAL Does not boot to Bios
Just to have it clear. Did you try to scan for the disks without the battery and the memory module? Did you try to enter the RAID BIOS (CTRL+G) when using the memory module and battery but without the...
View ArticleRe: cold reset of IPMI required after S2600WT maintenance?
thanks for reading my questions and asking for details. During the maintenance, we did not change the firmware. We rather extended the server by another NIC. We already had the PCIe x710 in and...
View ArticleRe: S5000PAL Does not boot to Bios
I can get into the raid config utility with the drives removed. I's ctrl C at this point. Which gets me into the configuration utilityPut the drives back in, I removed the activation key, F2 into bios,...
View ArticleIntel SAS Backplanes
Guten Tag,ich möchte diese Diskusion eröffnen, da anscheinend viele Probleme mit den BackplanesAXX6DRV3GEXP und AXX4DRV3GEXP haben.Ich leider auch.Zum Problem: Ich habe mehrere dieser Backplans mit...
View ArticleRe: intel s5000vsa sata board raid configure support needed
You may want to disable the Quiet Boot option in BIOS under the Main tab. With the onboard controller you should be able to get a CTRL+E prompt to enter the RAID BIOS. I noticed that the second drive...
View ArticleClik here to view.
Re: raid support for INTEL S5000VSA needed
Possible solutions for this issue are being discussed here.
View ArticleRe: intel s5000vsa sata board raid configure support needed
thanks for your support.1. first i will do the bios setup as per your guidelines.then i will check for ctr+E option is dispaying.2. then i will connect WD hard disk (500gb)--2nos...
View ArticleRe: intel s5000vsa sata board raid configure support needed
ok sir.i check it out & get back to u
View ArticleRe: intel s5000vsa sata board raid configure support needed
ok sir i check it out & get back to u
View ArticleRe: Intel SAS Backplanes
In welchem Gehäuse wird die Backplane betrieben? Normalerweise ist die Backplane für das Intel SC5400 oder 5600 vorgesehen. Dort gibt es eine SGPIO Kabelverbindung (graues dünnes Kabel). Dieses wird...
View ArticleHow to install VGA Driver on Server 2012 Foundation on S1200KP?
Hi, everytime I try to install the video driver from the S1200KP on Windows Server 2012 Foudnation it don't work, I just get an error message without any description also if I accept EULA. Hopefully...
View Article