Re: ESRT 2 SATA & SAS SOFTWARE RAID DRIVE
You need to configure RAID first, and then install OS on the RAID VD. RAID driver needs to be loaded during OS installation. The step-by-step demos below will tell you how to do that: Demo:...
View ArticleRe: Difference between a Mod Server Compute Module MFS5000SIB andMFS5000SI
Correct; the only difference is the 3-pack.
View ArticleRe: can not detect pci port server board S2400SC
Which RAID card is it? Sometimes you have to disable some of the other existing RAID options in the BIOS, before an add-in card will be recognized.
View ArticleRe: S5000PSLAS Motherboard Pin-out
Check page 35 (46 of 112) of the Intel� Server Board S5000PSL — S5000PSL and S5000XSL technical product specification
View ArticleRe: Firmware Bios vs. Operating System
Hello, Seann - The operating system software should be completely separate from the BIOS settings, for the most part. If you are enabling ESRT2 RAID, that normally would delete anything on the hard...
View ArticleRe: MFSYS25 - MFS5520VIR - Action 'Power On' failure on 'Server 4'
Hello, Nate - You are correct, three power supplies is enough for 4-6 compute modules, normally. If you go into the dashboard, what does it show your current power usage at? Even with all the memory...
View ArticleRe: MFSYS25 - MFS5520VIR - Action 'Power On' failure on 'Server 4'
The Current Load reads: 401.17 watts I thoroughly reviewed the firmware update documentation to insure there were no power-related "fixes". The fixes that are listed in the Release Notes for each...
View ArticleRe: Firmware Bios vs. Operating System
Yes it lost..it cannot save ESRT 2 in mass storage controller, it all come back again in AHCI default when rebooted, and booted in OEM windows server 2008. How can I reflash the BIOS of Intel server...
View ArticleRe: Firmware Bios vs. Operating System
it doesn't change when i set mass storage controller to RAID and press F10 to save and quit but it all detects the hard drive in mass storage..when booted it always go to windows server 2008, i...
View ArticleRe: Firmware Bios vs. Operating System
i dont have any adapter or RAID controller attached on PCIe just using the embedded RAID onboard only to create a RAID array..
View ArticleRe: S5000PSLAS Motherboard Pin-out
Hi Dan_O, thank you very much, this looks like what I needed. I had already downloaded several pdf's for the motherboard but hadn't come across this one. Again, many thanks!
View ArticleRe: S1200V3RMP / XEON E3 1275V3 HDMI audio problem
Hi Dan,thanks a lot, that's great.I have been doing a bit of testing with the board in the meantime (Win 8.1 64bit).- a Dragonfly USB DAC is detected and functions without problems (24bit/96kHz)- a...
View ArticleRe: Firmware Bios vs. Operating System
Seann - You can reflash the BIOS using this download - Download Center If the board still isn't saving your settings, it might be worthwhile to double-check to make sure you don't accidentally have a...
View ArticleRe: W2600CR2 memory installation order
A1, C1; E1, G1. The "farthest fill" rule is, start with the outer blue slots, and fill inward as you go. See page 30 of the Server Products — Technical Product Specification
View ArticleRe: W2600CR2 memory installation order
Thanks much, that is exactly what I was looking for, I just didn't know where this documentation was. Good job!
View ArticleRe: MFSYS25 - MFS5520VIR - Action 'Power On' failure on 'Server 4'
We received the power supply and successfully installed the device in the IMS. After the hardware installation was complete, the IMS permitted the 4th compute module to be powered on and now the...
View ArticleClik here to view.
Server board S2600CP2 1-5-1-2 beep code
I just bought brand new Intel server board S2600CP2, installed with 128 (16*8G DDR4-1600) RAM, 2 X E5-2620 processor, attached all power cable (server board, 2 CPUs), with 1000W PSU, but when I try to...
View ArticleRe: Disk Write Cache on board RAID ESRT II
Do you mean sir in system cache on ESRT 2 that doesn't have BBU capabilty, the write back will turn off in system Raid. if onboard RAID will use? may i know and ask if our Intel server board s1200bts...
View ArticleRe: S2600CP and VMWare 5.5
I've searched around and tried a few how-tos, but I really don't know how to make my USB drive use the MBR format instead of the UEFI format. I was able to create an MBR using DISKPART in Windows 7,...
View Article