Re: S1200V3RP won't boot
Hello, Here are our recommendations: 1. Test the system without the processor installed looking for a 1-5-4-2 beep code sequence.2. Test the system without memory installed looking for 3 regular beep...
View ArticleClik here to view.
Re: S1200V3RP won't boot
Thank you for the reply. As you recommended:1) removed processor - same result; green power LED on and no other activity, no beeps2) removed processor and memory - same result; green power LED on and...
View ArticleRe: Need help with BIOS update: S3210SH server board / CentOS 6.5
The prime cause why I'm doing this is kacpid, which takes 50% of the CPU sometimes. Furthermore I've got a warning from DMAR. And I suspect also a problems with cpu power regulation:dmesgInitializing...
View ArticleRe: Will the Mezzanine Module slot still avaliable, when a Core i3 CPU is...
Hello, To answer your question, the mezzanine module slot will be available since the lanes are handled by the BMC directly.
View ArticleRe: S1200V3RP won't boot
Hi, Please contact our support group directly for assistance on replacing the board under warranty: http://www.intel.com/p/en_US/support/contactsupport
View ArticleRe: S5520UR do not not recognized PCI-E 1x controller based on sil3132
Hi, We recommend testing a different card on the slot for testing purposes. If the card is detected, you are dealing with a compatibility issue with the SiI3132 and there is no much troubleshooting we...
View ArticleClik here to view.
Re: Need help with BIOS update: S3210SH server board / CentOS 6.5
Hello, We regret to inform that the assistance we offer for Linux is limited reason why we recommend using the EFI shell instead to update the firmware and BIOS for this specific system: Intel®...
View ArticleRe: Need help with BIOS update: S3210SH server board / CentOS 6.5
Thanks, that helps! But now sys fan(s) is at its maximum speed all the time. Is it configurable? Was it my fault or not: being asked about chassis type I've answered "unknown". Cause I really don't...
View Articleмат. плата S1200BTSR и RAID
Есть материнская плата S1200BTSRбудет ли работать с ней след железо:raid - RAID контроллер Intel RS3FC044оперативная память - 8Gb DDR-III 1600MHz Kingston ECC Reg (KVR16R11D8/8)
View ArticleClik here to view.
Re: Need help with BIOS update: S3210SH server board / CentOS 6.5
Hi, It will be really helpful to identify which chassis you have in order to provide accurate information but if not, run the firmware update again and make sure to select option #1 at the end of the...
View ArticleClik here to view.
2.8 Gbyte/sec limitation on RMS25CB080
3 series of tests on Intel R2216GZ4GCLX server show maximum read speed about 2.8Gbyte/sec, then theoretical maximum is 6Gbyte/sec (6Gbit/s per port, 8 ports)Drives: 10 Intel SATA SSD 730 240Gb...
View ArticleGrafik Driver for S2600CW2
I'm looking for a graphics driver from Intel for a S2600CW2 Server Board Thanks Celly
View ArticleRe: 2.8 Gbyte/sec limitation on RMS25CB080
First, while LSI 2208 chip advertised with PCI-E 3.0 capability, Intel states for RMS25CB080 only Gen2 PCI Express lanes, resulting in 4 GB/s peak. Second, the diagram of LSI 2208 shows a 4.8 GB/s...
View ArticleRe: Need help with BIOS update: S3210SH server board / CentOS 6.5
Sorry for a delay. There are one CPU fan and one frontal SYS fan connected to sysfan_2 port. So i've reconfigured sdr properly, but nothing changed. Inside the case I see that SYS fan is at moderate...
View ArticleRe: 2.8 Gbyte/sec limitation on RMS25CB080
Thanks, is very useful document, however it doesn't explain value 2.8Gbyte/s. Besides, I don't understand restriction 4.8Gb/s on 8 SAS ports (page 15). If each port transfers 6Gbit/s, 8*6Gbit has to...
View ArticleClik here to view.
Re: Will the Mezzanine Module slot still avaliable, when a Core i3 CPU is...
Thanks for reply! But what does "lanes are handled by the BMC directly" mean?You mean that the PCIe Gen2 x4 lanes are first connect to the BMC, then the BMC route these lanes to the mezzanine module...
View ArticleRe: Grafik Driver for S2600CW2
I am moving this thread to the appropriate support group Servers Allan.
View ArticleRe: Need help with BIOS update: S3210SH server board / CentOS 6.5
Hello, We strongly recommend contacting our support group directly for further assistance on this issue: http://www.intel.com/p/en_US/support/contactsupport
View ArticleClik here to view.
Re: мат. плата S1200BTSR и RAID
Hello, Please provide a detailed description of the issue in English in order to provide accurate assistance.
View ArticleRe: 2.8 Gbyte/sec limitation on RMS25CB080
If each port transfers 6Gbit/s, 8*6Gbit has to give 6Gbyte, right? You forgot about signal encoding. 6Gbit/s is a raw PHY level rate, at ATA protocol level you have only 4/5 of it, thus only 4800...
View Article